L3 10G 8 ports industrial Switch (8*1000M PoE+4*1G/10G SFP)

L3 10G 8 ports industrial Switch (8*1000M PoE+4*1G/10G SFP)

Categories:
  • 描述
  • Inquiry

Industrial 8G POE with 4*10G SFP+ Managed PoE Switch

8*1000M PoE+4*1G/10G SFP

Model S12PM8G4SE
Product Industrial 8+4 Managed PoE Switch
Downlink Port 8*10/100/1000M RJ45 ports

Port 1~2 support af./at/poe++/BT ( MAX 90W)

Port 3~8 support af/at(single port power MAX 30W)

Uplink Port 4*1000M/10000M SFP
Console Port 1
Reset Key 1
CPU 500M
DDR 2G DDR3 1333MHz
Buffer Fully integrated 1.5 MB packet buffer
FLASH 64M
RAM 256M
Bandwidth 256Gbps
Packet Forwarding 92.32Mpps
MAC 16K
Power Input 2 group of independent power input

SW:DC12-57V

PoE:DC37-57V

PoE:DC37-57V

Environment Detection 1 group of input detection of environment temperature and humidity
Function Interface (only for enhancement model) 1 switch for quick formation of ring network

2 group of independent power input, having under- and over-voltage protection

1 group of wide voltage alarm input at a range of DC5-57V

1 group of alarm output and relay output, can define various custom condition trigger

1 group of environmental temperature and humidity detection, can make real-time monitoring of the environment

Real-time system of crucial voltage monitoring and alarm output function

Real-time system temperature, environment temperature,humidity and alarm output function

Real-time detection and display of input voltage, current, power

Multiple custom port control and intelligent management

Network protocol IEEE 802.3

IEEE 802.3u 100BASE-TX

IEEE 802.3ab1000BASE-T

IEEE 802.3x

IEEE 802.3z 1000BASE-X

IEEE 802.3ad

IEEE 802.3q 、IEEE 802.3q/p

IEEE 802.1w、IEEE 802.1d 、IEEE 802.1S

STP(Spanning Tree Protocol)

RSTP/MSTP( Rapid Spanning Tree Protocol)

EPPS ring network protocol

EAPS ring network protocol

IEEE 802.3802.3AF/AT/HiPoE/BT

Port Specification 1-8 port 10/100/1000BaseT(X)auto detection,AUTO-MDI/MDI-X
Transmission Mode Store and Forward(full wirespeed)
Transmission Distance 10BASE-T : Cat3,4,5 UTP(≤250 meter)

100BASE-TX : Cat5 or later UTP(≤100 meter)

1000BASE-TX : Cat6 or later UTP(≤1000 meter)

Watt Standby power consumption:MAX 30W

Full load power consumption≤360W

LED Indicator 9-12:(SFP LED)

Port 3-8(Green=LINK LED;Orange=1000M LED)

PWR:( Power/system LED)

P1:(Master power LED)

P2:(Slave power LED)

HW:(Ring network ON LED)

Power Consumption Standby power consumption≤10W;

Network Full-load power consumption≤30W;

Full load power consumption≤360W

Operating Temperature/Humidity -40~+80°C;10%~90% RH No coagulation
Storage Temperature/Humidity -40~+85°C;5%~95% RH No coagulation
Lightning Protection Level 6KV 8/20us;8KV ESD

IP40

Product Size(L*W*H) 188*130*50mm
N.W(kg) 1.3kg
Installation DIN guide rail type(additional wall hangers)
Certificate CE mark, commercial;CE/LVD EN60950;
FCC Part 15 Class B;RoHS;
Warranty Whole device for 1 year(Accessories not included)

 

Software function

Features L3 Switch
Port
Number of Copper Gigabit ports 8
Number of Fiber 10G or 1G ports 4
Port Shutdown Support
Port Speed Support auto negotiate, full-1000, full-100, half-100, full-10, half-10
Flow Control support full-duplex IEEE 802.3x, half-duplex back pressure
Storm Control Supports rate limit for broadcast, multicast, and DLF packets
Storm Constrain Support the detection of broadcast packets, multicast packets,

or unicast packets on the port, shutdown the port if the rate is over the threshold.

Port Mirror Support
Port Rate Limit Support port ingress and egress rate limit
Link Aggregation Support manual link aggregation

Support LACP dynamic link aggregation

Supports up to 32 aggregation groups, each group up to 8 ports

Support source MAC, destination MAC, source destination MAC, source IP, destination IP, source destination IP routing strategy

Port Isolate Support
Jumbo Frame Support up to 16KB packet
Redundant Port Support
MAC
MAC Table Capacity 16K
MAC Table Management Support
Forwarding mode Support IVL forwarding mode
Static MAC Address Support
MAC Address Binding Support
MAC Address Filtering Support
MAC Learning Control Control the MAC learning based on port
VLAN
Number of VLANs 4K
802.1q-based VLAN Support
MAC-based VLAN Support
IP-based VLAN Support
Protocol-based VLAN Support
Voice VLAN Support
VLAN Mapping Support 1:1 mapping
QinQ Support basic QinQ

Support flexible QinQ

Reliability
Spanning Tree Protocol Support STP/RSTP/MSTP
Port Loop Detection Support
EAPS Support
ERPS Support G.8032/Y.1344
LLDP Support LLDP & LLDP-MED
UDLD Fully compatible with CISCO’s UDLD protocol
VLLP (VRRP Layer-2 Loop Protection) Support, Only used with VRRP
L3
ARP Support static and dynamic ARP
Static Route Support
VLAN Interface Support 32 VLAN interfaces
RIP Support RIP v1/v2
OSPF Support OSPFv2
Policy Route Support
VRRP Support
Multicast
Static Multicast MAC Address Support
IGMP SNOOPING Support IGMP SNOOPING v1/v2/v3

Support IGMP Querier

Support IGMP SNOOPING Filter

MVR Support
GMRP Support
ACL
Standard IP-based ACL Support
Extended IP based ACL Support
MAC IP-based ACL Support
MAC ARP-based ACL Support
ACL Port Filtering Support
Time-based ACL Support
QoS
Port Queue Number 8
Port Queue Scheduling Mode Support WRR,RR,WDRR,SP
Port-based Classification Support
802.1p-based Classification Support
DSCP-based Classification Support
ACL-based Classification Support
QoS Policy Support packets mapping to queue

Support COS or DSCP Remarking

Support rate limits of data flow

Support data flow statistics

Support mirroring of data flow

DHCP
DHCP Client Support
DHCP Snooping Support
DHCP Relay Support
DHCP Server Support
DHCP option 82 Support
Management
CLI  Management Support Console, Telnet and SSH
WEB Management Support HTTP and HTTPS
SNMP Management Support SNMP v1, v2c

Support SNMP TRAP

Support lots of standard and private MIBs

User Management Support multiple user management
Log Management Support local log management

Support SYSLOG

RMON Support RMON 1, 2, 3 and 9 groups
Cluster Management Support NDP

Support NTDP

Support manual and automatic joining of cluster groups

Support cluster unified management

Configuration File Support uploading and downloading configuration file
Upgrade software Support
Clock Management Support local clock management

Support SNTP

Security
Switch Management Security Support enabling and disabling TELNET, WEB and SNMP services

Support TELNET, WEB and SNMP services to bind to standard IP ACLs

Support for limiting the number of TELNET connections

CPU Protection The switch’s own security protection prevents large data streams from attacking the switch itself.
AAA Support 802.1x

Support RADIUS

Supports authentication, authorization, and accounting through RADIUS server

Support port-based and MAC-based 802.1x

Support 802.1x guest VLAN

IP MAC Binding Support static configuration of IP, MAC and port binding
DHCP SNOOPING Support dynamic ARP binding to prevent ARP spoofing

Support dynamic IP, MAC and port binding

Support fixed port to connect to DHCP server to prevent private connection to DHCP server

Prevent ARP Spoofing Support manually configuring MAC ARP-based ACL rules to prevent ARP spoofing.

Support the DHCP SNOOPING function. During the process of obtaining an IP address by DHCP, the switch dynamically binds ARP to the port to prevent ARP spoofing.

POE
Switch Control Support POE powering of ports on and off
Power Control Support setting total power
Other Advanced Features Support POE scheduling policy and PD online query, etc.
Debugging
PING Support
TRACEROUTE Support
TELNET Client Support